EV Conversion - Nissan Leaf Gen2 PDM/Charger split and rotate plates

These plates can be used when you need to remove and rotate the PDM/Charger on a Nissan Leaf Gen 2 stack
Manufacturer: Active Automation (NZ)
$175.00 incl tax

Nissan Leaf Gen2 PDM/Charger split and rotate plates 

 

These plates can be used when you need to remove and rotate the PDM/Charger
On a Nissan Leaf Gen 2 stack

I you have removed the nissan gear box
The PDM/Charger module on the top has a lot of over hang
If you roate it 90 deg it allowes for a smaller space in the engine bay
And can give you clearace need for a Land Rover firewall when connected to its gear box.

 

After plates attached to PDM/Charger
And the Invter below
You can use spaccers to set them apart the height need for extending the HV leads

Customers who bought this item also bought

EV conversion - Nissan Leaf front motor mounting plates

These are 5mm steel plates that can be used to hold up front of Gen 2 Nissan leaf motor

$175.00 incl tax

EV Conversion - Land Rover flywheel coupling to leaf motor (Diesel)

This is a coupling that allows you to connect the flywheel and clutch on to (Diesel version) On to a Nissan motor output splined shaft.

$1,120.00 incl tax

EV Conversion - NSK 6012ZZC3 bearing

NSK 6012ZZC3 bearing Used with the coupling bearings when protecting from pressure of clutch

$60.00 incl tax